MDS MX-2104 Specifikace stáhnout pdf (Strana 194)

Appendix F Command Set Description MX-2100/2104 Installation and Operation Manual

F-16 Commands

Use

1. Type:

DEF DP <ENTER>

If the KCL.2 module has an Ethernet interface, the following is displayed:

ROUTING_PROTOCOL

NONE

where NONE is the default value.

If the KCL.2 module has RS-232 interfaces, the following is displayed:

SPEED DATA PARITY CALL_OUT_MODE

9600 8 NONE NO

where the parameter values are the default values.

2. Change the parameter values as follows:

 Bring the cursor to the beginning of the first field to be changed by

pressing the space bar.

 To change the selected field, press F or B to scroll among the available

selections.

 When the desired selection is displayed, press the space bar to move to

the next field.

• When done, press ENTER.

The second line of parameters is displayed. The following is a typical

display:

LOG_OFF AUXILIARY_DEVICE ROUTING_PROTOCOL

NO NMS_SLIP NONE

Table F-2 shows the dial-out parameters and their values.

Table F-2. Dial-out Parameters

Designation Function Values

SPEED Selects the dial-out port data rate. 300, 1200, 2400, 4800, 9600, 19200, 38400 and

57600 bps

DATA Selects the number of data bits in the

dial-out port word format:

7 or 8 data bits

PARITY Controls the use of parity. ODD - Odd parity

ODD - Odd parity

EVEN - Even parity

NO - Parity disabled (only available with 8 data bits).

CALL_OUT_MODE Controls the use of the call-out

function:

NO - Call-out function is disabled.

YES - MX-2100 will initiate a call after each new

alarm.

1 2 ... 189 190 191 192 193 194 195 196 197 198 199 ... 242 243

Žádné komentáře

MDS MX-2104 Specifikace Strana 194