MDS MDS 9710 Series Specifikace stáhnout pdf (Strana 24)

16 MDS 4710/9710 I/O Guide MDS 05-3305A01, Rev. D

3. Conﬁgure the HHT as listed in Table 8.

NOTE: In rare cases, it may be necessary to reset the HHT to its

factory defaults before any configuration can be performed. To

do this: Hold the and

keys simultaneously,

while plugging in the power cable into the HHT.

4.3 Keyboard Commands

Table 9 on Page 17 is a reference chart of software commands for the

transceiver. Programmable information is shown in brackets [ ] fol-

lowing the command name. See Section 4.4, Detailed Command

Descriptions (Page 19) for detailed command descriptions.

Entering Commands

To enter a command, type the command, and then press the

key.

For programming commands:

1. Type the command.

2. Press the key.

The appropriate information or values follow.

3. Press the

key.

Here are some additional points to remember when using the HHT:

• Use the key to access numbers; press again to return to letter

mode.

• Use the key to edit information or command entries.

• The flashing square cursor ( ) indicates that Letter Mode is

selected.

• The flashing superscript rectangular cursor ( ) indicates that

Number Mode is selected.

Table 8. HHT Operational Settings

Parameter Setting Parameter Setting

Re-init HHT NO Scroll On 33rd

Baud Rate 9600 Cursor ON

Comm bits 8,1,n CRLF for CR OFF

Parity Error OFF Self Test FAST

Key Repeat OFF Key Beep ON

Echo OFF Screen Size 80

Shift Keys YES Menu Mode LONG

Ctl Chars PROCS

CTRL/Z

ENTER

SPACE

ENTER

SHIFT

ESC/BKSP

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 57 58

Komentáře k této Příručce

Žádné komentáře

MDS MDS 9710 Series Specifikace Strana 24

Komentáře k této Příručce