MDS MDS 9710 Series Specifikace stáhnout pdf (Strana 33)

MDS 05-3305A01, Rev. D MDS 4710/9710 I/O Guide 25

KEY

TX Key This command activates the transmitter. See also the DKEY command.

MODEL

Model Number Code This command displays the radio’s model number code.

MODEM [xxxx, NONE]

Analog/Digital

Modem Selection

This command selects the radio’s modem characteristics. For digital

operation, enter

9600 (MDS x710A) or 19200 (MDS x710C). For analog

operation, enter

NONE.

When the

MODEM is set to NONE, the analog TX Input and RX Audio out-

puts of the

DATA INTERFACE are used to interface with the connected

external modem. These levels must match the audio signal level require-

ments of the external modem. See “RXLEVEL [–20 to +6]” on Page 27

and “TXLEVEL [–20 to +6, AUTO]” on Page 29 for details on setting

these levels.

OWM [XXX...]

Owner’s Message This is a command to display or program an owner’s message. To pro-

gram the owner’s message, type

OWM then the message, followed by

To display the owner’s message, type

OWM then . The owner’s

message appears on the display.

OWN [XXX...]

Owner’s Name This is a command to display or program an owner’s name. To program

the owner’s name, type

OWN then the name, followed by .

To display the owner’s name, type

OWN then . The owner’s

name appears on the display.

PTT [0–255]

Push-to-Talk Delay This command sets or displays the key-up delay in milliseconds.

This timer specifies how long to wait after the radio receives a key signal

from either the PTT or RTS lines (on the

DATA INTERFACE), before actu-

ally keying the radio.

PWR [20–37]

TX RF Power

Output Level

NOTE: This function might not be available, depending on certifica-

tion requirements in a particular country.

ENTER

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 57 58

Komentáře k této Příručce

Žádné komentáře

MDS MDS 9710 Series Specifikace Strana 33

Komentáře k této Příručce